

Now available, optional "Sennheiser" Driven micro-sized capsules (omni-directional )!!! Incredible sound quality...guaranteed!!! These are matched sets and are high-end microphones.The (MM-BSM-8) True & Natural Hook On In-Ear Stereo Microphones are a set of miniature in-ear speakers modified and designed to give you the "most" realistic and accurate binaural stereo recordings!
Totally flexible and form fitting the (MM-BSM-8) will give you hours of comfortable recordings hands free! Microphones install quick and easily over the ear and slide into and next to the opening of each ear. When installed correctly microphones will not fall out! Comes standard gold plated 90 degree 1/8" stereo plug for even greater flexibility. Cable lengths are 52".
*In-Ear Binaural Stereo Microphones "do not" block your hearing ability!
These microphones have a very naturally crisp sound, providing deep bass, smooth mid-range and clean high-range with a frequency response of typically +/-2dB. They can be easily plugged into any Minidisc, Dat or analog recorder that supplies a bias voltage of between 1.5 to 10 volts D.C. (also known as plug in power) at the microphone input jack.
Note: If your recorder does not provide a bias voltage or if you want to feed your recorders line inputs to avoid overloading your recorder's mic pre-amplifier, you can use one of our Battery Modules (check out our Battery-Module Section).
Battery Modules will power the microphones with optimum power ( 9 volts D.C ), increase dynamic range and enable the mics to handle higher (SPL) sound pressure levels ( loud sounds ) without distortion.
SPECIFICATIONS
Frequency response: 20- 20,000 Hz
Signal to noise ratio: 62dB, 1khz at 1pa
Open circuit sensitivity : -35dB (5.6 mv) re 1v at 1pa
Dynamic range: 95dB, 1kHz
Maximum Input Sound Level: 105dB SPL (120 db when used with one of our battery modules), 1kHz at 1%
FEATURES
Flat frequency response
Requires a bias voltage of 1.5 to 10 volts D.C. (also known as plug-in- power) or one of our battery modules.
Includes Life- Time Warranty at no extra charge!
"Sennheiser" Driven SPECIFICATIONS
Frequency response: 20- 20,000 Hz
Signal to noise ratio: 65dB, 1khz at 1pa
Open circuit sensitivity : 10 mV +/- 2.5 db re 1v at 1pa
Maximum Input Sound Level: 130dB max SPL with out a battery module!
"Sennheiser" Driven / FEATURES
Flat frequency response
Requires a bias voltage of .9 to 15 volts D.C. (also known as plug-in- power) or one of our battery modules.
Includes Life- Time Warranty at no extra charge!
ACCESSORIES
Check out our Battery/Filter Module Section
|